“Please Execute APR”
Not a fault. Run APR (Automatic Pixel Restoration) when prompted. It takes about 30 seconds.
The buttons don’t do anything
Check the HOLD switch on the right side.
I can’t select a frame rate or format I want
The Imager Scan Mode limits what’s available. FF 6K only goes up to 30fps, so use S35 4K for 50/60fps, or a 2K mode for 100fps and above. Choosing a frame rate above 30fps in FF 6K switches the camera to S35 4K automatically.
The picture looks flat and grey
You’re in Cine EI. Choose a LUT in MENU → Shooting → Monitor LUT → LUT Select, or turn on Gamma Display Assist.
My footage has the LUT baked in
Monitor LUT Setting → Internal Rec is on. Turn it off.
“Media Needs to be Formatted”
Format the card in the camera (TC/Media → Format Media). This erases it.
“Media Near Full” or “Media Full”
“Near Full” means less than 5 minutes are left, so swap soon. “Full” means recording has stopped.
I can’t change the SDI or HDMI output format
Picture Cache is on. Turn it off, change the output, then turn it back on.
There’s no sound
- Check the AUDIO LEVEL dials and the CH1/CH2 INPUT switches.
- For XLR mics, check the INPUT switch, and use MIC+48V if the mic needs phantom power.
It won’t switch on after connecting power
Turn the POWER switch off, disconnect, wait about 30 seconds, then reconnect.
Still stuck?
As a last resort, use MENU → Maintenance → All Reset. Or call us on 0141 420 2053. We’re here Mon–Fri 8:30–5, and out-of-hours help is available through the same number.
Back to the FX9 quick start · FX9 full setup
Need one for your shoot?
Hire our Sony FX9 from Progressive in Glasgow, with XQD cards, a card reader and batteries.
Call 0141 420 2053 or get in touch for a quote.



